|
Post by ktyoung05 on Dec 29, 2014 16:20:19 GMT -5
I have a 1981 Yamaha PW 50 that I can't seem to get running. It didn't run when I got it. I have tried cleaning out the carburetor (which is like new), installed new reeds, piston & Cylinder (had low compression), new stator and flywheel (didn't have any spark and the flywheel had a broken magnet),new handlebar switch, new CDI box, new coil, new spark plugs (tried a couple NGK's). At one time it ran for about 5 minutes, but the engine ran backwards (hit the gas and the tire turned backward). It has not run since. It has great spark, is getting fuel to the combustion chamber, it must be out of time, which is not adjustable. I've never had this problem ever with a 2 stroke, and this headache is making me NEVER want to buy a Yamaha EVER again (I've had a couple that needed constant attention and repairs, and they were fairly new!!!) I have even blocked off the oil injection and plugged the carb to run pre-mix fuel. When the engine ran backwards, the kick starter turns the engine clockwise which the manual says is correct, but would cough just enough to start running, backwards.......I've wasted a lot of valuable time on this thing. I even went and bought a Suzuki 50, just because it did run so the kids had something to ride.....RRRRRRRRRRR!!!!!!
|
|
|
Post by ktyoung05 on Jan 18, 2015 11:42:28 GMT -5
got the bike running tonight, it was the wires that were messed up.
|
|
|
Post by Thomas on Dec 19, 2015 7:31:08 GMT -5
Hi,
I have the same problem. Can you tell me which of the wires were messed up? I installed a new ignition plate, because the spark was not strong enough. Thomas from Austria
|
|
|
Post by Sanchez001 on Jan 1, 2016 18:59:23 GMT -5
Hi,can you tell me what cables do you switch,thank you!!!
|
|
|
Post by jools on Aug 15, 2016 23:17:52 GMT -5
Hi Can you please tell me which wires were mixed mine runs backwards too
|
|
travo
New Member
Posts: 1
|
Post by travo on Aug 22, 2017 18:57:00 GMT -5
Which wires and what was the solution?
|
|