|
Post by carb on Jan 23, 2009 15:23:46 GMT -5
i bought a used pw50 and the carb has no lines running to it i can tell which ones is the fuel line inlet but what are the other two for the oil tank has been taken off so do i cap the off or what? and i bought a new carb for it any suggestion on adjusting one out of the box?
|
|
|
Post by turbomart on Mar 12, 2009 18:50:15 GMT -5
there is a hose connection point at the bottom of the float bowl. There you shoul connect a hose ending under the bike. It's the overflow outlet. The oil inlet connection is higher up at the neck just behind where the carb connects to the cylinder intake/reeds. Did you buy the carb from 50ccparts? I bought one from ("MINIKY", not "MIKUNI") them and it worked right out of the box. The service manual states: Main jet 70 Air screw 1 3/8 turns out from fully seated Needle clip pos 2 (from top).
|
|