|
Post by Green_Lantern on May 25, 2015 4:04:33 GMT -5
the specs are the following main jet 70 pilot jet 40 float height 15.5-17.5 air mixture screw (std settign) 13/8 turns out. these should basically get it started Pilot Jet is the main culprit. If it gets stuck and you can't back it out with a slotted head screwdriver to try and clean it then you will need to drill it out using a left handed or reverse drill bit set with an extraction kit. In an emergency you could go to home depot and buy a RYOBI Size #1 spiral screw extractor and a RIDGID size 5/64" regular cobalt drill bit al for around $4.70 plus tax. You will need a drill,hammer,crescent wrench to complete the job but it will get the stuck pilot jet out. Refer to youtube.com and see how its done. Here is the link: www.youtube.com/watch?v=z4Mf9UPpCas. Harbor freight also carries an affordable set that I'm gonna pick up.
|
|